Data Processing FAQ
If installing an integration, creating a task, or changing a data flow does not produce the expected result, check the steps associated with the symptom. This helps you determine whether to complete the configuration, verify the deployed version, or investigate exception data.
The Integration Shows Installed, but No Corresponding Task Appears in the Data Task List
First, determine whether you have only installed the integration resources or have also saved the ingestion configuration.
Checks
- Open the target custom integration's Configuration tab and check the data center, task name, and monitoring component settings.
- Confirm that you have saved the ingestion configuration. If you have not configured it, follow Create a Data Task.
- After saving, go to Data Framework → Data Processing and look for the task by name in the data task list.
Expected Result and Next Steps
If you find the corresponding task, check its status and data flow. If you still cannot find it, retain any messages shown when saving and investigate the save result. The Installed status alone does not confirm that a task has been created.
Pending verification: The distinction between installing resources and saving a configuration to create a task is based on the PRD. Saving and task creation have not been tested for this documentation. These steps provide a troubleshooting path, not a confirmed sole cause of a reproduced issue.
New Data Still Uses the Previous Processing Rules After a Data Flow Change
First, confirm that the modified version is deployed and that the data you are checking belongs to the target task.
Checks
- Open the target task's details and check which version in the data flow version list is deployed.
- If the modified version is not deployed, follow Task Management to publish the required version.
- If the target version is deployed, check the component execution order and configuration, then inspect the results for data subsequently received by that task.
Expected Result and Next Steps
Only one data flow version can be deployed for a task at a time, and subsequent incoming data should be processed by that version. If the version and component configuration are correct but the results are still unexpected, see Exception Data to inspect the raw exception data and error messages, then locate the processing component involved.